The catalogue is the starting point, not the limit
A non-standard thread, a longer probe, a different wetted material or a signal your control system already speaks — these are normal orders when the people quoting them are the people building them. Describe the duty and we will tell you what it takes.
What can change
Six parameters, set on the line
These are the variables the factory can move without becoming a different product. Anything outside them is a development project, and we will say so at the review stage rather than after the order.
Process connection
G1/2 and M20×1.5 are standard across most families. Other thread standards, flange and sanitary connections are machined to the drawing.
Threads · flanges · vessel connections
Probe length and diameter
Level and temperature probes are cut and welded to the vessel depth you specify, in diameters from 3 mm upward depending on the family.
3 mm – 5 m depending on principle
Wetted material
SUS 316L is the default. Where the medium attacks 316L, the probe, flange and seal material are selected against the medium rather than assumed.
316L · PEEK · custom wetted parts
Range and output
Measuring ranges are set at calibration, and output type — relay, PNP/NPN, 4–20 mA, 0–10 V or RS485 — is selected at order.
Relay · analogue · Modbus RTU
Housing and protection
Standard housings are IP65–IP67. Submersible assemblies are rated IP68, and explosion-proof housings are available for the gas and pressure ranges.
IP65 – IP68 · Ex housings
Temperature rating
High-temperature versions extend the medium ceiling beyond the standard 80 °C — for example the HSM flow switches and the TPS/TPT probes rated to 450 °C and above.
To 450 °C and higher on selected families
How it runs
From process conditions to a unit on the bench
- 01
Send the process conditions
Medium, temperature, pressure, pipe or vessel size, area classification, and the signal your control system accepts. A sketch or a photograph of the existing installation is more useful than a specification.
- 02
Engineering review
We come back with the nearest catalogue model, the changes needed, and any condition that the instrument cannot survive. If a catalogue item will do the job, we say so rather than quoting a special.
- 03
Drawing and quotation
For a non-standard build you receive a dimensioned drawing and a quotation before anything is cut. Changes to the drawing at this stage cost nothing.
- 04
Build, calibrate, ship
The unit is assembled and calibrated against the agreed specification, then supplied with its documentation. Repeat orders keep the same build parameters.
Common requests
What buyers usually ask for
If your requirement is on this list, it has been built before and there is a known answer.
Longer probe than the catalogue
Level and temperature probes are made to vessel depth.
Thread the plant already uses
Other thread standards, flange and vessel connections machined to drawing.
Aggressive medium
Wetted material selected against the medium, not against the default.
Signal the PLC accepts
Relay, analogue or RS485 selected at order.
Higher temperature
High-temperature variants on selected flow and temperature families.
Hazardous area
Explosion-proof housings on the gas and pressure ranges.
OEM marking
Neutral or customer-branded labelling for machine builders.
Repeat batch
Build parameters held for reorders so a second batch matches the first.
Fastest route for a custom enquiry
Email the process conditions and any drawing or photograph of the existing installation. That skips the form and puts the enquiry straight in front of an engineer.
Not sure whether you need a custom build? Start from the catalogue — most enquiries are answered by a standard model.
Need a model that is not in the catalogue?
Send us the medium, range, thread and output you need. Most custom configurations are quoted from the factory engineering desk rather than handed to a trading partner.