Factory-direct manufacturer · Xiamen, China · Exporting worldwide

Flow Sensors & Switches

HSM10 Thermal Flow Switch

Single set-point

Request a quote

HSM10 technical data

Measurement

Measuring range — water
0–5 m/s
Measuring range — oil
0–10 m/s
Measuring range — gas
0–20 m/s
Maximum pressure
100 bar
Temperature gradient
Max. 250 K/min
Thermal response time
≤ 12 s

Electrical

Supply voltage
DC 24 V / AC-DC 110 V / AC-DC 220 V
Current consumption
< 80 mA
Output
Relay, PNP, NPN or 4–20 mA (specify at order)
Switch timing
ON typ. 2 s (1–13 s); OFF typ. 2 s (1–15 s)
Indication
6 LEDs; red = below set-point, yellow = at or above set-point

Mechanical

Wetted material
SUS 316L
Process connection
G1/2″ standard, others to order
Medium temperature
−20 to +80 °C (high-temperature version available)
Ingress protection
IP67

Values are for the standard configuration. Ranges, threads, probe lengths and output types outside this table are available on request — the datasheet revision for a custom build is issued with the quotation.

Request the PDF datasheet →

Flow Sensors & Switches

HSM10Thermal Flow Switch

Single set-point

Thermal-dispersion flow switch with a single adjustable set-point, sealed all-in-one stainless body rated IP67 and 100 bar. Relay, PNP, NPN or 4–20 mA output, G1/2 thread as standard. No paddle and no moving part in the flow path, so scale and debris cannot jam it.

Engineering reply · Evaluation samples available · Custom ranges built to order

  • No moving parts in the flow path — unaffected by debris and scale
  • All-in-one sealed construction, fully waterproof
  • Low thermal drift, so the set-point stays where you put it
  • Relay, PNP, NPN and 4–20 mA output options
  • Treated probe resists fouling in poor-quality water

How it works

The HSM10 detects flow by heating a probe slightly above the medium temperature and measuring how quickly that heat is carried away. Moving liquid or gas removes heat faster than a still column, so the electronics can decide whether the pipe is flowing and trip a relay at your set-point. Because the sensing element is a solid stainless probe with no paddle, vane or orifice, there is nothing for scale, sludge or debris to block. The probe face receives a surface treatment that resists the corrosion and fouling that shorten the life of ordinary flow switches in poor-quality water. Once the trip point is set, the unit holds it without periodic adjustment, which matters on plant that cannot tolerate an instrument drifting out of calibration.

Ordering notes

  • Set-point is fixed at the factory to your stated velocity unless you ask for field adjustability.
  • For sanitary or aggressive media, specify the probe material and thread at the time of enquiry.

Typical applications

  • Pump dry-run protection on water and coolant loops
  • Cooling-water flow confirmation on welders, furnaces and induction heaters
  • Lubrication and hydraulic circuit monitoring
  • Boiler feedwater and condensate lines
  • HVAC chilled-water and hot-water branches

Not certain HSM10 is the right unit?

Send the medium, range, process connection and the signal your control system accepts. We will confirm the model — or tell you which one fits better — before you commit to an order.

Same family

Other flow instruments

View the family →